18913053888
The positioning piece, also known as the positioning piece, is the most economical basic component for clamping electrodes.
The positioning piece can be directly installed on the electrode blank. In this way, the electrode fixture is also matched with ITS. The layout of installation holes simply requires drilling templates or NC programming methods to directly drill holes on the blank.
Specification: One set of 2 pieces, corrosion-resistant, each set contains 4 M5 support foot screws.
Application: Small electrode.
Installation: Directly installed on the copper block surface of the electrode clamp.
System accuracy of positioning piece on chuck: 0.002 mm
Positioning plate 50: applied to small electrodes.
Positioning piece 90 M8: applied to workpieces and electrodes.
Human error: After using the fixture system, all positioning is ensured by the fixture, eliminating losses caused by human error or electrode center error.
Testing: Each electrode is tested outside the machine, saving time and ensuring accuracy, eliminating the need for calibration on the machine, greatly improving the utilization rate of the machine.
Standard interface: The workbenches of all machine tools are consistent, unifying the connection ports of various machine tools, making the conversion between various processes smoother.
Speed: Switching from one process to another, with just a simple step, can quickly reset your machine tool to achieve rapid replacement of workpieces, without the need to mark and align, truly increasing the production time of the machine!
Cost: Adopting a standard benchmark system can greatly improve economic efficiency, and you will receive more production time, better output, and higher production capacity
The electrode positioning film is currently mainly produced by foreign products, and domestic enterprises are also constantly rising. Foreign brands include Erowa, 3R, etc., while domestic brands mainly include Dongwei Seiko, etc.
